TopTek was started by material and mechincal engineers. We will definetly improve all aspects based on our professional experience at material selection, component designing and application guiding.Developing together with you and helping you reach your targets are always one of our key principles.Our experienced engineer group members are glad to share with you about designing, molding, sintering, fine machining and application depends on your requirements.Do not hesitate to contact Advanced Ceramics Expert for amazing solutions.

Some General Guidelines

1. In general, the less we do to the ceramic part after it is sintered, the less it cost. Here is a list of the processing after sintering in order of cost increasing to ceramic part.

-Sintering

-Grinding

-Lapping

-Polishing

2. The different choice of machining also cause the different cost of ceramic part. Below there is a list of machining operations in order of cost increasing to ceramic part.

3. Avoid sharp internal corner and undercut to save the cost and away from stress riser.

4. Avoid knife edge features, because the brittleness of the ceramics.

5. Provide radius and chamfer on each edge to prevent from chipping whenever possible.

6.Tight tolerance causes expensive cost.

极速飞艇大小单双计划 极速十一选五 极速赛车正规吗 北京麻将算钱规则 亚得股票配资 如何看股票k线图视 山西快乐10分奖金多少 广东11选5今天开 武汉麻将红中赖子杆下载官游戏 捕鱼大师鳄鱼版旧版 1分快3全天精准计划 内蒙古11选5下注网 麻将机遥控器 大发快三是骗局吗 广东36选7最新开 排列5彩票软件 辽宁35选7最新开奖结果查询