TopTek was started by material and mechincal engineers. We will definetly improve all aspects based on our professional experience at material selection, component designing and application guiding.Developing together with you and helping you reach your targets are always one of our key principles.Our experienced engineer group members are glad to share with you about designing, molding, sintering, fine machining and application depends on your requirements.Do not hesitate to contact Advanced Ceramics Expert for amazing solutions.

Some General Guidelines

1. In general, the less we do to the ceramic part after it is sintered, the less it cost. Here is a list of the processing after sintering in order of cost increasing to ceramic part.

-Sintering

-Grinding

-Lapping

-Polishing


2. The different choice of machining also cause the different cost of ceramic part. Below there is a list of machining operations in order of cost increasing to ceramic part.


a.Avoid sharp internal corner and undercut to save the cost and away from stress riser.

b. Avoid knife edge features, because the brittleness of the ceramics.

c. Provide radius and chamfer on each edge to prevent from chipping whenever possible.

d.Tight tolerance causes expensive cost.

极速飞艇大小单双计划 深圳风采35选7开奖结果 好玩火爆棋牌游戏 稳定大底组选50注 内蒙古11选5一定 股票涨跌颜色设置 贵州福彩快3游戏规则 捕鱼王app安卓下载 天天斗棋牌? 汇金国际棋牌 湖北快三查询结果 越南河内5分彩走势图 黑龙江11选五5开奖走势图 如何分析股票涨跌 江苏体彩7位数官网 360股票行情 网站赚钱